JamesB Posted May 2, 2021 Report Share Posted May 2, 2021 Is there some placement issues with this? Because I have 3 firepits placed in a corner and only one of them will get to 1300 degrees. The other two just sit there at 700. Is this a known bug or a feature? Link to comment Share on other sites More sharing options...
Saricane Posted May 2, 2021 Report Share Posted May 2, 2021 What is the size of those firepits (x,y,z) ? Are you absolutely sure the wood in well enclosed ? And what do you get with the two "faulty" firepits ? Did the process stop and let your wood as is ? Link to comment Share on other sites More sharing options...
JamesB Posted May 2, 2021 Author Report Share Posted May 2, 2021 4 hours ago, Saricane said: What is the size of those firepits (x,y,z) ? Are you absolutely sure the wood in well enclosed ? And what do you get with the two "faulty" firepits ? Did the process stop and let your wood as is ? I didn't realize firepits could be larger than 1 square. What does it mean by "wood is well enclosed"? Right now my setup is like this: Link to comment Share on other sites More sharing options...
Saricane Posted May 2, 2021 Report Share Posted May 2, 2021 My bad. I thought you were talking about creating charcoal (I read firepit, I thought charcoal pit). That's why I did not understand your problem I'll give a try the same config, to see if I encounter the same problem. Link to comment Share on other sites More sharing options...
Saricane Posted May 2, 2021 Report Share Posted May 2, 2021 This is approximately the same configuration as yours. Everything is Ok. Link to comment Share on other sites More sharing options...
JamesB Posted May 2, 2021 Author Report Share Posted May 2, 2021 Weird. I'll give it a try again. I just wanted to make sure I wasn't doing something wrong by putting them all so close. Thanks! Link to comment Share on other sites More sharing options...
Recommended Posts