kaydragxn Posted Monday at 06:39 AM Report Posted Monday at 06:39 AM I don't know if this is an issue due to mods, or how i've done something wrong, but i cannot use my new huge windmill for what it was intended for. If i place even 1 quern under an axle, the whole system stops. But it will accept 12 pulverizers. There are 4 max-length sails connected to two large wheels at the top, and I pathed downwards and placed more as-needed until i had 12 axles. I really don't know where I went wrong because everything is fine and spinning.. until I introduce the querns.
marmarmar34 Posted yesterday at 03:22 PM Report Posted yesterday at 03:22 PM Does it spin out and stop? If so, give it some time. It might just be calculating the amount of power it needs before starting again. Other than that, I'm not sure there's any sort of hard cap that causes that to happen.
Zane Mordien Posted 19 hours ago Report Posted 19 hours ago On 1/26/2026 at 1:39 AM, kaydragxn said: I don't know if this is an issue due to mods, or how i've done something wrong, but i cannot use my new huge windmill for what it was intended for. If i place even 1 quern under an axle, the whole system stops. But it will accept 12 pulverizers. There are 4 max-length sails connected to two large wheels at the top, and I pathed downwards and placed more as-needed until i had 12 axles. I really don't know where I went wrong because everything is fine and spinning.. until I introduce the querns. Might want to share a picture of what you are doing and maybe what mods. I'm not sure from your description what you mean by two large wheels on top and are you running both the pulverizers and the querns at the same time?
Maelstrom Posted 4 hours ago Report Posted 4 hours ago Two large wheels (I assume large gears) are at the top where the windmills are? You should only need 1 large gear to aggregate the power from the windmills to transmit the power down to your workshop.
Recommended Posts